CEO Edition Humidor Instructions

Features

Humidity set point controller.

Removable serving tray.

Storage for approximately 75 cigars.

Continuous air circulation and venting.

No moving parts/Maintenance free.

Reduces the mixing of tobacco flavors.

 

Setup

This humidor is shipped fully assembled and ready to use. Simply unwrap and remove any packaging material.

Fill water pan located under the cigar tray with water, to about ¼" below the top.

Plug into any 110 volt outlet.

Set the desired humidity level on the HUMICON controller.

 

Operation

Always unplug the power when adding water or cleaning.

When water is needed the indicator next to the humidity controller will light.

To extinguish the indicator light press the red button located to the right of center on the water pan, between the two electric connections.

If it becomes necessary to remove the water pan simply pull up on both sides at the same time. The pan is held in place with Velcro so there is a tearing sound as it is removed. Make sure the unit is unplugged and there is enough extra power cord available to pull through the humidor as the pan and control box are lifted and removed.

 

Recommendations

The recommended humidity level is 72% RH but it maybe set to whatever is individually preferred. Bear in mind humidity fluctuations will occur depending on ambient conditions. If fluctuations are noticed leave at set point. The unit will balance itself.

If possible use distilled water. This will greatly decrease the frequency that the water pan will require cleaning.

When storing a large number of cigars for extended periods rotate their positions about once a month.

 

Cautions

Add water indicator is on even though there is water in the pan.

Press the red button located to the right of center on the water pan, between the two electric connections.

Humidor level too low

Check the power cord to make sure it is plugged into a working socket.

Never plug the humidor into a socket that is controlled by a switch. It may be accidentally turned off either periodically or for extended periods causing the cigars to dry out.

Removing water pan

Make sure the humidor is unplugged and there is enough extra power cord available to pull through the humidor as the pan and control box are lifted and removed. Remove the pan by pull up on both sides at the same time. The pan is held in place with Velcro so there is a tearing sound as it is removed.